High production and low energy
consumption 40D L/D ratio single screw extruder
HIEX series single screw extruder
integrates the design,production of Liansu
Machinery extrusion device with actual using experience, and joint research and
development with European experts, adopts advanced design concepts and technologies.HIEX
series machinery becomes the optimized choice of high production and low energy
consumption extrusion in HDPE,PP-R, PP-H and other PO type pipes.It
guarantees stable extrusion of single layer or multi-layer (diameter 16-1600MM)
L/D ratio: 40:1
The technology (L/D ratio 40)
improves the melt quality on the basis of increasing output rate and reduces the energy consumption.
Optimize the geometry parameters of
The optimization of screw structure
will directly affect the efficiency of extruder,therefore,the
research and improvement of screw structure has been ongoing,for example,optimize
mixing units and shear elements.Ensures the
soft melt processing and uniformity of melt mixing at low melting temperature.
Spiral slotting feeding section
Only the lower friction force is
produced during the transportation of material particles to ensure optimum
feeding and optimal conveying.Thus, it
guarantees the constant conveying rate under the high and low back pressure as
well as the linear output of extruder in the whole rotation speed range.
A powerful drive system with high
High strength silencing reducer,reduces
transmission wear, matching high power density, high efficiency,the
motor can achieve low noise operation <80dB (A), to ensure the
high-efficient constant torque extrusion in large range.
A deep integrated control system
Intelligent weighing control system
software is deeply integrated in PLC control system,to
achieve good quality extrusion pipe with superior cost performance.